HART Multiplexer System KFD*-HM*-16
Configuration
DO
C
T-0
120D
06/
2014
42
Before start the HART Scan select the desired options:
Setting Scan functions
Open the Scan parameters via
Settings
folder.
The
Settings
window is indicated.
The following parameters are adjustable:
•
Start Scanning for active slaves
: This option is used to determine whether a
search for connected Slaves is to be run.
•
Add found slaves
: This option is used to determine that the Slaves found are
added to the project.
•
Connect found slave DTMs
: An automatic connection is established to the
Slaves found.
•
Make scanning for HART devices
: This option is used to determine whether a
search for connected HART devices is to be run.
•
Automatically add found devices to project
: This option is used to determine
that the HART devices found are added to the project.
•
Use generic HART DTM (In case if after scan no device DTM was
assigned)
: If no HART DTM has been installed for the device found, the generic
HART DTM will be added instead.
•
Use first available device DTM (In case if after scan more then on device
DTM was assigned)
: If several DTMs have been installed for a device found, the
first DTM found will be added to the project.
Figure 6.13 Parameterization of HART Scan function
