peplink MediaFast 200, User Manual

Page: 80 / 278

USER MANUAL
Peplink Balance Series
http://www.peplink.com -80 / 269 - Copyright © 2016 Peplink
12 Configuring the LAN Interface(s)
LAN Interface settings are located at Network>LAN>Network Settings. Begin setting
up your physical LAN by entering IP settings (VLAN configuration will be covered
following physical LAN setup).
IP Settings
IP Address &
Subnet Mask
Enter the Peplink Balance’s IP address and subnet mask values to be used on the LAN. To
enable multiple VLANs, press the button on the top right-hand corner.
If drop-in mode will be used, you can configure it in the next section.
Drop-in Mode Settings
Enable
Drop-in mode eases the installation of the Peplink Balance on a live network between the
existing firewall and router, such that no configuration changes are required on existing
equipment. Check the box to enable the drop-in mode feature.
Please refer to Section
13
, Drop-in Mode for details.
WAN for Drop-
In Mode
Select the WAN port to be used for drop-in mode. If WAN 1 with LAN Bypass is selected,
the high availability feature will be disabled automatically.