12
© 2010 PeopleNet Communications. All rights reserved.
DC-DC Installation
2. Locate the
DC-DC Power Supply
ground and power connector shown in Figure 6.
(This connector can only be used on some factory pre-wired trucks.)
Figure 6: Ground and Power Connector
3. Using wire cutters clip off the connector and strip the ends of the wires. Connect the Blue wire to vehicle
ground.
4. Using a butt connector, connect an inline 15 AMP fuse to the Brown wire and connect to vehicle constant
power.
Do not insert fuse at this time
.
Wire Color Description
Brown
Co12 Volts (Not Switched)
Blue
Ground
Summary of Contents for eDriver Logs BLU.2
