Operators manual for the Pentruder 6-12HF and Pentpak HF-power pack – Original instructions
Page
10
Intended use of the Pentruder 6-12HF and Pentpak HF-power pack
Pentruder 6-12HF is intended to be used together with a Pentpak HF-power pack and may only be
used for cutting of concrete and similar materials. It is our expressed recommendation that the
machine
not
be used for cutting in any other materials. The Pentruder 6-12HF saw head cannot be
used with other types of power packs. If connected to other types of power packs (frequency
inverters) Tractive AB disclaims any responsibility for the product.
Warning! Please observe that Tractive’s responsibility as a manufacturer can only be
accepted when the saw head, Pentruder 6-12HF, is used together with power packs, machines
and accessory equipment of Tractive’s manufacture and origin. If the Pentruder saw head is
used with non-original equipment the warranty will be void.
The Pentpak is primarily intended to power Pentruder HF-wallsaws. It is also used for powering
other machines of our manufacture, like the MD1, 4-speed drill gearbox, as well as our wire saws.
Please contact your distributor for information. Please observe that Tractive’s responsibility as a
manufacturer only can be accepted when the Pentpak is used together with machines and
accessory equipment of Tractive’s manufacture and origin.
Important! Always consult Tractive AB or our representative before any other type of machine
or equipment than the Pentruder 6-12HF is connected to the power pack. Observe that
Tractive’s responsibility as a manufacturer can only be accepted when the saw head Pentruder
6-12HF is used together with power packs, machines and accessory equipment of Tractive’s
manufacture and origin. If the Pentruder saw head is used with non-original equipment the
warranty will be void.
Safety precautions
It is of paramount importance that the operator has full knowledge and understanding of the
instructions below:
This wall saw may not be used unless the operator is fully familiar with the contents of this manual
and has been trained in its operation by an authorised distributor of Tractive AB’s products. The
operator is fully responsible for the manner in which the machine is operated. It is the responsibility
of the purchaser that the operator has received the information needed to operate and handle the
machine in a safe and correct way.
Warning! Faulty handling of the machine can expose the operator and / or persons in close
proximity to the machine to extreme danger.
Tractive AB disclaims all responsibility for damages to persons and / or property resulting from use
of the machine, whether they are caused by faulty handling or from damages that have occurred as
a consequence of negligent or faulty maintenance, or as a consequence of failure to check and
control the machine with regard to damages and / or faults.
Warning! A Pentruder wall saw used in the correct way is a safe and efficient tool. If the
machine is used improperly this can expose the operator and other persons staying in the
same area to extreme danger or even risk of fatal injuries.
Warning! Basic safety precautions are that all persons present in the same area or in the
same place as the machine shall wear protective equipment including helmet, safety shoes,
gloves, eye and ear protection, and that all other safety precautions applicable on site are to be
respected.
Warning! Track stops must always be securely mounted at each end of the track(s) to prevent
the saw head from being run off the track unintentionally.
