Operator’s manual Pentruder
®
3P8 HF-wire saw and Pentpak - Original instructions
22
2. Attach the main drive pulley
a.
Attach the main drive pulley on the lower assembly by mating the two dowel pins to the dowel holes in the
magazine plate.
b.
Tighten the lock bolt with a 14 mm Allen key socket and a long ½” extension.
Main drive pulley assembly
Fitting of main drive pulley assembly
3. Fit slip clutch (not mandatory but recommended) and main drive HF-motor
a) Align the splined drive shaft and clamp studs with the holes in the drive pulley assembly plate.
a)
Rotate the main drive pulley very slowly by hand until the spline fits and HF-motor seats properly.
c)
Tighten the clamp screws with an 8 mm Allen key / 5/16”.
d) Repeat a-c for the HF-motor
