18
(5) PUMP
To turn the air pump On, press the Air Pump ON/OFF switch. The switch will beep when pressed. Then the LED on the switch
will light and the sound of the air pump will be heard. To turn the air pumps OFF, press the ON/OFF switch again. The switch will
beep and the LED on the switch will turn OFF.
There are two (2) air pump levels, LOW and HIGH. The switches will beep when pressed and the LED on the level switch will light
to indicate the selected level. The air pump level will control the pressure of both the air and water delivery.
- Regardless of pump level setting selected, avoid delivering too much air to minimize the potential for pneumatic
perforation or barotrauma.
- Should debris on the objective lens be difficult to clean, one can temporarily use a higher pump level setting on the
video processor or light source. While doing so, simultaneously activate the air and suction control valves to minimize air
insufflation. After the lens has been cleared return the air pressure to its original setting for routine use. Regardless of pump
level setting selected, avoid delivering too much air.
CAUTION
NOTE
Summary of Contents for EPK-1000
Page 1: ...PENTAX VIDEO PROCESSOR EPK 1000 OWNER S MANUAL ...
Page 42: ...39 MEMO ...
Page 43: ......