Pentair Sta-Rite EcoSelect Enviromax 800, Owner'S Manual

Page: 11 / 20

Operation
4. Priming
Press the “STOP” button for 5 seconds to DISABLE/ENABLE
prime time. (The power LED/ Green will light up and not blink
when prime time is disabled), this function will be back to
default when reset to default or press again this button for 5
second.
Pressing any two of the speed buttons simultaneously to
finish priming time as temporarily.
Pressing the “STOP” button for 10 seconds the power LED/
green will blink twice in every one second then display will
show “P 2” and ready to adjust time (Limit time to 240min
maximum and minimum for 1Min)
Pressing the button ”low” will lower the time by 1 min step
(Holding for 2 seconds to decrease time continuously)
Pressing the button “high” (will rise the time by 1 min step
(Holding for 2 seconds to increase time continuously)
Pressing the button “med/set” will save the new time then
automatic go to Priming speed setup in next step and display
show “2850” and ready to adjust speed
Pressing the button “low” will lower the speed by 25 RPM
step (Holding for 2 seconds to decrease speed continuously)
Pressing the button “med/set” will save
,
or
Disabl
e or Enabl
e the
Prime Time
Priming time and Priming speed setup
10