SPACOMMAND
®
Spa-Side Remote Installation and User’s Guide
2
Operating the Spa-Side Remote
The spa-side remote can control up to ten system functions, depending on the system
being used (EasyTouch, IntelliTouch and Compool
control systems). Each circuit function
can be labeled above the buttons to identify the button function. An LED indicator light
behind each button indicates which circuit is active. When one of the circuit buttons is
pressed, the LED indicator is illuminated, indicating that the circuit has been activated.
Note: For IntelliTouch system only: IntelliTouch automation supports multiple spa-side
remote. For more information about connecting and configuring multiple remotes, see
page 15.
•
Set Spa Temperature
: Press the
Mode
button until
WTR TEMP
LED is
illuminated. Use the
/
button to adjust the current spa temperature.
The current temperature display will blink while it is being adjusted. After
setting the desired temperature, the display shows the actual
temperature as it adjusts to the set temperature. This only functions while
in the “Spa” mode. The temperature set by the remote is only temporary.
When the “Spa” mode is switched OFF, the temperature set at the
EasyTouch
®
or IntelliTouch
®
Automation System control panel will resume
the next time the spa mode is activated using the “Set manual heat”
function (see the EasyTouch automation User’s Guide (P/N 520584) and
IntelliTouch automation User’s Guide (P/N 521075) for details. The “Spa”
mode will automatically switch off after 24 hours.
•
TIME LED:
View the current EasyTouch or IntelliTouch system time.
•
RPM LED:
Press the
/
button to step increment the pump speed
(RPM) for the IntelliFlo
®
VS Pump(*).
•
GPM LED:
Press the
/
button to step increment the flow rate (GPM)
for the IntelliFlo VF pump*.
See page 18 and 19 for IntelliTouch and
EasyTouch menu setup information.
Note (*): The pump’s RPM or GPM selection is determined by the pump
type (IntelliFlo VS or VF) pump being used. To adjust the pump speed
(RPM) or flow rate (GPM) in step increments, press the
Mode button
and
select either RPM (LED on) or GPM (LED on). The
/
button will
illuminate. Use these buttons to step increase or decrease the RPM or
GPM. The preset step speed and flow rate increments are set in the
EasyTouch automation menu feature “iSx Pump Cntrl > Assign iS10” and
IntelliTouch automation menu feature “SPA SIDE IFLO CONTROL” setting
which determine the pump and step size to use. Press the
Mode
button to
save and exit.
•
BKLT LED:
Adjust the LED display and button backlight brightness from
20-100%. Adjusting the display brightness will only take effect after dark.
To adjust the display brightness, press the
Mode
button and select
BKLT
(LED on). The
/
buttons will illuminate. Press the
/
buttons to set
the display brightness from 20 -100%. Press the
Mode
button to save and
exit.
•
AIR TEMP:
View the current outside ambient air temperature.
HEAT LED:
The Heat LED illuminates when the spa button circuit is pressed to
activate the spa heater, indicating the spa heater circuit is on.