SolarTouch Controller Firmware Update User’s Guide
SolarTouch Controller Firmware Update User’s Guide
6
3. With the front (LEDs) of the PICKit
®
4 programmer facing you, connect
the programmer (pin 1 on right side) onto the 5-pin connector (pin 1 on
right side) on the control panel circuit board (PCB) as shown below.
Pin 1 on PCB
Pin slot on PCB
(not used)
4.
Switch ON power to the SolarTouch Controller
.
5. Next, load the MPLAB IDE software.
Continue with Launching the IPE Programming Application on the next page.
PICKit 4 programmer plugged into SolarTouch Controller circuit board.
Pin 1
Pin 5
Note: Be sure to align Pin
1 on the programmer and
Pin 1 on the SolarTouch
circuit board
Connect Programmer to SolarTouch
®
Control Panel (Continued)
USB Cable to
PC USB Port
SolarTouch
Circuit Board
Pins 1-5
