SLIMLITE Pool Light Installation and User’s Guide
6
Always install a new lens gasket (P/N 620400Z) whenever
disassembling the SlimLite light assembly. Failure to do so may
permit water to leak into the assembly which could cause:
(a)
an electrical hazard resulting in death or serious injury to pool users,
installers, or others due to electrical shock, or
(b)
breakage of the lens, which likewise could result in serious injury to pool
users, installers, or bystanders, or in damage to property.
SLIMLITE POOL LIGHT DISASSEMBLY INSTRUCTIONS
(IN AN EXISTING POOL)
1.
Turn off main electrical switch or circuit breaker
, as well as the switch which
operates the SlimLite light itself.
Note: DO NOT
service the light while in
the pool water. Service the light on the deck.
2. Before starting be sure that you have a new Lens Gasket (P/N 620400Z) ready
to install.
Removal and Installation of the SlimLite Light assembly
D A N G E R !
RISK OF ELECTRICAL SHOCK OR ELECTROCUTION
Always disconnect power to the pool light at the circuit breaker
before servicing the light. Failure to do so could result in death
or serious injury to installer, service person, pool users, or
others due to electrical shock.
When replacing the SlimLite Light assembly, the LENS GASKET (P/N
620400Z) MUST ALSO BE REPLACED - SEE PAGE 14 FOR PART
NUMBERS.
3. Place a cloth on the ground to protect to protect the light housing grille.
4. Using a 1/4” Hex head driver, remove all of the eight (8) hex head
screws.
Remove the Clamp ring and from the light housing.
See Figure 7.
5. With the light resting on its base, carefully pry off the gasket to remove the
lens. Set the lens aside for installation later.
Discard the gasket.
Note: A NEW LENS GASKET (P/N 620400Z) MUST BE USED EACH TIME
THE LIGHT IS REASSEMBLED.
See page 14 for Replacement Kit part numbers.
