10
GREAT WHITE
®
II Automatic Pool Cleaner Installation and User’s Guide
This
Not
This
Figure 26
Figure 25
Figure 24
Seals
Figure 22
Figure 23
#10-16x1" Screws
#10-16x1-3/4" Screws
Center
Brush
Location
Lift Brush
Location
Center
Brush
Location
Bottom View of Cleaner
Start here with
large button when
installing vacuum skirt.
OUTSIDE
'Outside' will show
(facing out) when
skirt is correctly installed.
Rubber
vacuum skirt
Figure 27
Reassembly
1. Put both white seals in the oscillator; hold them in place.
2. Install the oscillator on the long gear shaft. Install the ratchet
gear on the shaft so that the teeth engage the ratchet on the
oscillator. Install the spring, ratchet drum, pinion gear (large
gear first), and cam (gear end first) on the shaft (
see Figure
22
). Hold the gears on the shaft while installing them, and
compress the clutch spring to allow assembly to slip into place
between the posts (
see Figure 22
).
3. Install the long gear shaft and end blocks in the cleaning head
with the large arm of the cam down (
see Figure 23
).
4. Reinstall the short gear shaft, set screw and two gears (
see
Figure 24
); the small pinion gears and the shaft set screw
go on the side toward the end of the cleaner – away from the
oscillator box. Make sure that the gears engage the gears on
the long gear shaft.
5. Install the oscillator chamber cap and clip it in place.
6. Install the rubber vacuum skirt on the cleaner with the word
‘OUTSIDE’ showing. Start at the large pin on the back of the
cleaner head (
see Figure 25
) and work around the cleaner.
Make sure the skirt is flush against the stop strips on the
cleaner head (
see Figure 26
).
7. Turn the cleaner over. If you removed the bumper and brush
ring, replace them now.
8. Install the lower body assembly in the shroud. Fasten the
cleaning head in place with 6 screws (2 long, 2 short –
see
Figure 27
).
NOTE:
Make sure that you do not dislodge the rubber vac
skirt while inserting the lower body assembly past the brush
ring.
