Installer manual Fleck 5800 XTR - Operation
90 / 126
Ref. MKT-IM-006 / E - 12.11.2019
8
Operation
8.1
Display during operation
wed
12:01 am
4.5
m³
Water Treatment
treatment
tank refill
rapid rinse
draw
backwash
8.2
Display during regeneration
48 m
34 s
Regeneration
treatment
tank refill
rapid rinse
draw
backwash
During regeneration, the regeneration cycle wheel shows the regeneration step the valve is
advancing to, or has reached (green), and the time remaining in that step (
1
). Once all
regeneration steps are complete the valve returns to treatment position and resumes normal
operation. The time remaining in regeneration will be displayed on the home screen in hours and
minutes.
Pressing the
button during a regeneration cycle immediately advances the valve to the next
cycle step position and resumes normal step timing. The
button is only shown when the valve
is in position and the motor has stopped.
8.3
Controller operation during programming
The controller can only be programmed with the valve in treatment. While being programmed the
controller continues to operate normally, monitoring water usage and keeping all displays up to
date. Controller programming is stored in memory permanently until reset.
8.4
Manual regeneration
From the home screen, press the regeneration button
to access the regeneration screen.
