Pentair FLECK 3150 NXT, Installer Manual

Page: 104 / 182

Installer manual Fleck 3150 NXT/NXT2 - Programming
104 / 182 Ref. MKT-IM-010 / C - 18.10.2019
a) Set the safety coefficient with , and ;
ð Can be adjusted from 0 to 50%;
ð Any value programmed above the maximum value
will be discarded and considered as the maximum
above mentioned value.
b) Press to validate the selection and advance to the
next parameter.
No safety factor
programmed.
Fixed volume
Set a fixed volume as safety reserve capacity.
Info
The availability depends on reserve type programmed in the previous step.
a) Set the reserve volume with , and ;
ð The volume range depend on capacity, in liter if
metric units were programmed or US gallon if US
units were programmed (see Units [
} Page 101] );
ð
The maximum reserve volume capacity settable
will correspond to the half of the total volume.
b) Press to validate the selection and advance to the
next parameter.
6.2.5.19 Remote regeneration
Set the regeneration type for remotely started regeneration (external dry contact input,
see chapter Electrical connections [
} Page 52]).
Info
This mode can be combined with the other methods of regeneration; the remotely
started regenerations overrule the other regeneration type once the signal is acquired.
Options:
• off;
• immediate;
• delayed.
a) Set the remote regeneration mode with and ;
ð Default setting: off;
b) Press to validate the selection and advance to the
next parameter.
Remote regeneration
deactivated.