Pentair F783E, Operating Manual

Page: 32 / 33

F783E Ex ‐ ia
Pg 32
00 ‐ ISN ‐ 203_Rev B
29/01/2021
Danger ‐ high pressure!
Before loosening lines and valves, turn o ff the pressure and vent the lines.
Danger of explosion when used in explosive atmospheres (only in the event of a fault in zone 2)
Opening the control top in an explosive atmosphere is only allowed in a non ‐ energised state
DANGER
!
Risk of injury due to electric shock!

Before reaching into the system isolate the power supply when it is deemed the power supply could be capable of
causing injury from electric shock!

Observe applicable accident preven on and safety regula ons for electrical equipment!
Risk of injury from improper disassembly!

Disassembly work should only be carried out by quali fi ed personnel and only with the appropriate tools
WARNING
!
Prior to star ng work, check the system status. Con fi rm all system power is isolated and it is safe to disconnect cables
!
Procedure:
Cable gland version

Open the control head (follow the instruc ons in chapter 8 “Opening and closing the housing” if in doubt).

Disconnect the cable termina ons from the terminal block. Slacken the gland nut and pull the cable through the gland.

Loosen the pneuma c connec ons (for detailed instruc ons see chapter 9 “Pneuma c installa on”.

Remove the two M6 caphead screws that retain the control head to the actuator.

Li the control head clear of the actuator and any target.

If necessary, remove the target and any adaptor plates (if fi ed).

Re fi t the cap to maintain the internal components in good condi on.

Store or dispose of the control head in accordance with the guidelines in chapter 13