background image

           

AquaLumin

®

 II - Nicheless Light Installation Guide

 

AquaLumin

®

 II - Nicheless Light Installation Guide

2

Technical Support

Contact Technical Support at:

Sanford, North Carolina 

(8 A.M. to 5 P.M.)

Moorpark, California 

(8 A.M. to 5 P.M.)

Phone: (800) 831-7133

Fax: (800) 284-4151

Web sites:  

visit www.pentairpool.com and www.staritepool.com

© 2008 Pentair Water Pool and Spa, Inc. All rights reserved

This document is subject to change without notice

1620 Hawkins Ave., Sanford, NC 27330 • (800) 831-7133 • (919) 566-8000
10951 West Los Angeles Ave., Moorpark, CA 93021 • (800) 831-7133 • (805) 553-5000

AquaLumin

n

®

 

II and the Pentair Water Pool and Spa

®

 are registered trademarks of Pentair Water Pool and Spa, Inc.

Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks
and names or their products. Pentair Water Pool and Spa, Inc. disclaims proprietary interest in marks and names
of others.

15

600140

Kwik change lens set

619613 - Green lens cover

Qty.  1

619614  - Orange lens cover  Qty. 1
619615  - Blue lens cover

Qty. 1

619616  -  Red lens cover

Qty. 1

600138

Bulb replacement kit 120V / 250V

619484 - Bulb (120V/250W) Qty.  1
619599  - Lens gasket

Qty. 1

619792 - Sealing screws

Qty. 10

600139

Bulb replacement kit 12V / 100V

619584 - Bulb (12V/100W)

Qty.  1

619599  - Lens gasket

Qty. 1

619792 - Sealing screws

Qty. 10

600141

Lens replacement kit

619797 -  Lens

Qty.  1

619599 -  Lens gasket

Qty. 1

619792 - Sealing screws

Qty. 10

 

Part

Number         Description

AquaLumin II Replacement Part Kits

Replacement Part Kits

Summary of Contents for Nicheless Light AquaLumin II









Reviews: