IntelliBrite
®
5g Pool LED Light Installation and User’s Guide
ite light (after electrical requirements are met)
1.
Feed cord through conduit to Junction Box, leaving at least four (4)
feet of cord at the light fixture to coil around the light; see Figure 1, on
page 7. The four (4) feet of cord around the light allows the light to be
serviced after the pool is filled with water.
2.
Cut the cord at the Junction Box, leaving at least six (6) inches of
cord to make connections.
3.
Strip back six (6) inches of the outer cord jacket to expose the three
insulated wires (be careful not to damage the insulation on the three
(3) inner wires).
4.
Connect all three (3) wires to the corresponding circuit wires in the
Junction Box and secure the Junction Box cover in place.
INSTALLING THE INTELLIBRITE 5G POOL LED LIGHT FIXTURE
(AFTER ELECTRICAL REQUIREMENTS ARE MET) (CONTINUED)
5.
Install the IntelliBrite light assembly into the niche
and tighten the special bronze pilot screw (see
Figure 1, on page 7.
Use only the
special pilot screw
provided
with this underwater light. This screw mounts
and electrically grounds the housing securely to the
mounting ring and wet niche. Failure to use the screw
provided could create an electrical hazard which could
result in death or serious injury to pool users, installers or
others due to electrical shock.
Pilot screw
(brass)
8
6.
Fill the pool until the underwater light is completely submerged in
water before operating the light for more than ten (10) seconds.
7.
Final check for proper light operation:
To check for proper
operation, switch on the main switch or circuit breaker, and the switch
that operates the IntelliBrite underwater light itself. The light should
illuminate when power is applied. If not recheck the installation steps
starting with Step 1.
If the light is not submerged in water and powered on for
more than 10 minutes, the light will switch off for a cooling down period of
10 minutes then power back on. This circuitry protects the light from being
potential damage.