3
Example one
SD50
PERFORMANCE CURVE
Example one illustrates a typical system installation.
7. Connect to power source using
3-prong grounded 115 volt
AC receptacle. Do not
remove ground pin from
electrical plug. Do not use an
extension cord.
8. For proper automatic
operation make sure the pump
power cord is plugged into
the back of the piggyback
receptacle on the switch cord.
9. Use pump submerged for
pumping waterlike liquids
(temperature to 120°F).
WARNING: Risk of
Electrical Shock – This
pump has not been
investigated for
use in
swimming pool areas.
10.
CAUTION:
Do not pump
flammable liquids, strong
chemicals or salt water.
11.In applications where the
pump may sit idle for months
at a time, it is recommended
that the pump(s) be cycled
every month to ensure
pumping system is working
properly when needed.
12.An audible alarm system such
as the Q Alert for high water
conditions should be installed
for additional protection
against high water conditions.
Summary of Contents for Hydromatic SW33
Page 6: ...6 SW SD VS33 50 Parts List...
