15
2009 AT8 M anual
• Remove all jumpers on JP1.
• Place a jumper between pins 1 and 3.
• Place a second jumper between pins 2 and 4.
• JP1 is now configured for line voltage.
3.5.1.7
line Voltage (Input Voltage) Sanitizer Output Voltage
• Insert the flow switch though the small strain relief in the bottom of the AT-8.
• Connect the flow switch wires into TB6 located on the circuit board.
• Place one wire in to the F+ slot, and one wire in to the slot.
• Polarity does not matter on these connections.
3.5.1.8
Flow Switch
*0
4"4"
44&
WArNINg
Power should be off to the AT-8 beforemoving JP1 jumpers.
• Run the temperature sensor through the small strain relief on the bottom of the controller.
• Connect the temperature wires to TB5 located on the circuit board.
• Place one wire in the T+ slot and one wire in the T- slot.
• Polarity does not matter on these connections.
3.5.1.9
Temperature Sensor
4"4"
44&
