- 14 -
WARNING
Housekeeping personnel should wear protective glasses and
gloves to prevent disinfectant from damaging their eyes or
skin. If disinfectant gets on the skin or in the eyes, rinse
thoroughly with plenty of water. Seek medical advice if
irritation occurs.
6. Using the long-handled brush, available from your Penner
distributor, thoroughly scrub all interior surfaces of the tub with
the solution that remains in the foot well of the tub. Let
disinfectant stay on surface for 10 minutes. (Or, as
recommended by the instructions on the disinfectant
concentrate container.)
7. Remove the plug from the drain.
8.
Rinse most of the soapy water away with the shower sprayer
9. Press and hold the Rinse button located on the control panel
shown in (figure 1) until clear water runs from all the air jets.
Then release the Rinse button.
10. Finish rinsing the interior surfaces of the tub with the shower
sprayer.
11. Start the air blower by pushing the Aqua-Aire Button. Allow it to
run for 30 seconds. This pushes the rinse water out of the air
injection system. If this was the last bath of the day, allow the
blower to run for 2 minutes to dry out the system.
12. Stop the Aqua-Aire blower by again pushing the Aqua-Aire
button on the control panel shown in (figure 1).
13. Visibly check that the tub was effectively cleaned during the
disinfecting procedure. If not, repeat the procedure.
