Comfort Warm System
The Comfort Warm keypad controls three levels of heat. Pushing the button repeatedly will cycle through the different levels
of heat with the first push being the hottest and the fourth turning the Comfort Warm off. They will also automatically shut
off after 30min.
Heating pads are stuck on with a high strength adhesive. If replacing, disconnect wire connections and peel off pad. Clean
with an alcohol wipe or non-residue cleaner and peel backing from new pad. Apply from center out of pad and press firmly.
Reconnect wires. Do not remove white insulation backing.
Load Center-Spa Control
Load Center-Comfort Warm System
760748 Rev C 10-1-2021
11
1-800-732-0717
www.pennerbathing.com
1-866-736-6377
Load Center 760500
The Load Center is a no repair item. If it has been determined that the load center is at
fault, replacement of the unit will be necessary. Open the lid, disconnect the air line,
blower motor supply, Comfort Warm power supply and then use a 3/8” nut driver to take
off the nuts (350955) to remove the unit.
1
2
3
4
1. Air Switch air line connection
2. Air Blower Motor Connection #3
3. Comfort Warm Keypad Connection
4. Comfort Warm power supply
1. Keypad
760560
1. Heating Pad
760550
2. Cable-Split
760555
(Not Shown)
1
1
