Penn Elcom FT80-Q Fittings Manual Download Page 3

Page: 3 / 4

FT80-Q FITTING GUIDE

You will

require an awl,

a cross head

screwdriver &

a 79mm (3

⅛

Hole Cutter

Position and tape down the template
and mark out the hole centres with an
Awl as shown.

Next drill the 4 internal mounting holes
3mm (

⅛

") pilot holes to a max depth

of 10mm (

⅜

Drill the centre hole right through

Now using the 79mm
(3

⅛

") hole saw

Cut the hole out from
both sides to avoid
breakout damage

This picture
shows the
finished hole
preparation

Summary of Contents for FT80-Q

Page 1: ...ure as the in board fans are just recycling hot air Technical Specifications Low Noise 22 5dBA 0 3 Sone 28CFM 47 6m h 2000 RPM High Static Pressure 1 x 9 Bladed 80mm Fan 12V DC 200mA 2 x DC In Out Soc...

Page 2: ...into the TEMP socket It is set to operate at 40 and will reset at 30 or 2 Using the acrylic adhesive pad it should be attached to an area where the sensor can pick up the ambient temperature of the eq...

Page 3: ...he template and mark out the hole centres with an Awl as shown Next drill the 4 internal mounting holes 3mm pilot holes to a max depth of 10mm Drill the centre hole right through Now using the 79mm 3...

Page 4: ...717 or www penn elcom com 2016 FT80 Q Cupboard Exhaust Unit is the exclusive design copyright of Penn Elcom UK NE37 1HB E OE Now offer up the fan unit and fix using the 4 cross head screws provided DO...