3.
Install threaded nipples or other threaded fittings in the housing. Be sure to use Tef-
lon tape on the fittings. Tighten them with channel locks. If flex pipes with rubber gas-
kets are used, there is no need to Teflon tape the outer fittings. If a normal plumbing
fitting is used, then be sure to Teflon tape the outer fitting.
4.
Mount the filter to the wall using the necessary fasteners for the wall type. Mark the
hole locations on the wall using a marker or pencil while holding the filter housing
level. If this is to be mounted to a studded wall, a mounting board can be used. A
shelf board or plywood can be mounted to the studs then the filter housing can be
screwed to the plywood or shelf board. (Plywood pictured below)
8