1
2
3
4
5
6
Extend the headband.
Pull out the cups.
Tilt the upper section of the
cup outward so that the
wire is on the outside of
the headband.
Adjust the height of the
cups.
Slide the cup up or
down while holding on to
the headband.
The headband should be
across the top of the
head.
Before you collapse the
headset,
slide the cups in
all the way.
Collapse the headband.
Make sure that the sealing
cups are not creased and
that they lie flat against
each other.
INSTRUCTIONS
Press and release both
buttons at once. You will hear
a beep in the earphones.
Press on the right-hand
(forward) button to
increase volume.
Press on the left-hand
(rear) button to reduce
volume.
ON AND OFF
INCREASING VOLUME
REDUCING VOLUME
In cold weather, warm the unit inside your coat
for 1–2 minutes before putting it on for best comfort.
The sealing rings should lie
flat against each other.
Turn the cups outward so
the attenuating cushions
and circuits can dry.
Reassemble.
See
Disassembly/
Replacement
.
CARE
Clean the cups, headband
and sealing rings with a rag
dipped in tepid water.
Never
dip the cups into the
water!
When
damp
Wrong
RIght
To replace batteries, loosen
the screw. Do not hold the
battery cover. Remove the
batteries if the unit is to be
stored a long time.
Do not store at temperatures of over +55
°
C,
for example in a windscreen or window.
Install the new rings by
pressing in place.
DISASSEMBLING/REPLACING SEALING RINGS
Insert your fingers under the
edge and pull straight out.
EN
All guides must be folded
down completely before you
can collapse the headband.
STORAGE
FP3511 ComTac VoIII(E)+(SE)
03-01-31, 13.30
16-17
