P/N UM596KL_596KL-C REV20190923_web
17
CALIBRATION
This scale has been factory calibrated, and does not require calibration prior to use.
If required, the scale can be calibrated following the procedure below. Calibration of your scale
is performed using calibrated kilogram (kg) or pound (lb) weight standards.
Minimum calibration
is 110 lb / 50 kg. Maximum calibration weight is 600 lb / 270 kg.
Note: Only weights certified
and traceable to national standards should be used for calibration procedures.
The calibration procedure is available in the advanced settings menu. Follow this procedure to
enter the advanced menu and calibrate the scale.
Operation
Display
1.
Press to power on the scale. Wait for “0.0” to appear on the
display.
“0.0”
2. Use a small screwdriver or thin tool
to press the advanced menu button
located underneath the display
head. You may need to break
through the “SEAL” tape located
over the button.
3.
When the button is pressed the display will show “SEtUP followed by
“UnIt”.
“SEtUP”
followed by
“UnIt”
4. Press
until “CAL ib” appears on the display.
“CAL ib”
5. Press
and “CAL-U” will appear on the display.
“CAL-U”
6. The default calibration weight unit is kilograms. To calibrate the scale
in pounds, press to enter the weight unit. Press to
change from kg to lb. When “lb” appears on the display, press
to confirm.
“kg” or “lb”
7.
Press and “CAL-0” will appear on the display.
“CAL-0”
8. Press . The display will show 4 or 5 digits as the Zero count
value. Then press again and “CAL-0” will appear on the
display.
“XXXXX”
followed by “CAL-
0”
9.
Press and “CAL-5” will appear on the display.
“CAL-5”
10. Press then enter the calibration weight. Press to
decrease the value or press to increase the value. Press
to move to the next digit..
“XXX”
ZERO
ZERO
HOLD
PRESS 3 SECS
FOR BMI MODE
ZERO
HOLD
PRESS 3 SECS
FOR BMI MODE
ZERO
ZERO
HOLD
PRESS 3 SECS
FOR BMI MODE
ZERO
HOLD
PRESS 3 SECS
FOR BMI MODE
TARE
BSA
HOLD
PRESS 3 SECS
FOR BMI MODE
ZERO
