6
H
H
OW
OW
Y
Y
OUR
OUR
A
A
PPLIANCE
PPLIANCE
W
W
ORKS
ORKS
Cautions
:
Do not try to operate your stove with viewing door open. Pellets will not feed under these
circumstances and a safety concern may arise from sparks or fumes entering room.
If you are not drawing combustion air from outside, care must be taken to allow for adequate air
make up, to avoid possible room air starvation when stove or other exhaust fans are in
operation.
It is highly recommended that you install a high quality
smoke detector
as well as a
carbon
monoxide gas
detector in the room where stove is installed. Care should be taken to make
sure detectors are in working order at all times.
Fuel in the form of wood pellets, shelled corn or grain is stored in the hopper. An
auger delivers the pellets to the burn grate. The fuel rate, or heat output, is set by
adjusting the feed rate touch pad, (settings 1 to 4). A fan provides combustion air
to the burn grate. The amount of combustion air in the burn grate is adjustable
and automatically changes as the fuel rate changes. The higher the fuel rate, the
larger the amount of combustion air and visa versa. The fuel burns in the burn
grate, producing heat. Some heat radiates out the front of your stove. The
majority of the heat passes around the heat exchange tubes and air plenum
around the firebox and is then moved into the room by the room air fan. A small
amount of heat must pass out the exhaust of your stove, along with gases, into
the atmosphere.
Your stove's heat output can be adjusted from setting 1-4, through the FEED
RATE touch pad, to vary your
heat output from Low to High.
The room air fan can be manu-
ally adjusted through the FAN
SPEED to run faster or slower
to correspond to the amount of
heat being produced. The
room air fan is also on a limit
switch, controlled to run on high when the stove reaches
higher temperatures and then resume the speed you had
selected once it cools to a lower
temperature.
Your stove can run efficiently over extended periods of time
and at different heat output levels as long as the fuel supply
is uninterrupted and
timely cleaning and maintenance is
preformed
. An example of how improper cleaning effects
operations is; the exhaust pressure switch will shut the pel-
let supply off and your stove will shut off if the exhaust sys-
tem becomes plugged.
The operations and maintenance of your PelPro Series of multi-fuel appliance are unique
and should not
be considered to be like a wood, coal, gas, electric, propane or oil heater, stove or appliance.
FUEL CONSIDERATIONS
Your
PelPro Series of Multi-fuel appliance
i
s
designed to burn the following:
1.
Wood pellets that comply with the Pellet Fuel Industries standards.
2.
A combination of up to 50/50 Wood Pellet and Shelled Corn
3.
100% Shelled Corn, using the supplied corn grate, and manual start only. NO IGNITER
PelPro Home & Shop Heater www.pelprostoves.com 6
Window
Burn Pot
Burn Grate
Heat Tubes
Tube Scraper
Ash Pit
Hopper
Fan Motors
Auger
Exhaust
Air Intake
Auger Motor
Base
Hopper Lid
as desired
as desired
Memory &
Fan Trim
Summary of Contents for HHPP2
Page 40: ...40 ...
