pellenc EXCELION 2 LH, User Manual And Operating Instructions

Page: 28 / 84

BRUSH CUTTER EXCELION 2 LH
53_154421-A
5. Screw in the middle part so that the wire enters the
cutting head and becomes less and less apparent.
Note
The length of the strimmer wire must be suffi-
cient for the blade on the safety guard to cut it.
Note
After fitting your cutting head on your tool, it is necessary to select it in the HMI to operate the tool. Refer to
Section 5.5.2, “Activation of the cutting head via the HMI menu”.
Dismounting the TAP CUT 2 / TAP CUT 3 from the tool
1. Insert the Torx 25 key (22) into the hole on the angle
gear.
2. If necessary, turn the head slightly so that the Torx
25 wrench (22) also fits into the corresponding hole
on the cutting head.
This action will allow the position of the motor shaft
and the support washer to be unlocked.
3. Turn the head clockwise to unlock the position.
4. Unscrew the head.
28