Pella 801P0101, Installation Instructions Manual

Page: 8 / 8

INSTALLING ROTO COVER AND CRANK
Note: Finish the interior of the window and allow
the window to dry before proceeding with these
instructions. (To open the window for finishing,
partially insert the lock handle into the jamb,
unlock the unit, temporarily attach the crank
handle and turn to open.)
A. Place the cover over the operator stud and snap
into place.
B. Apply pressure to the pocket end of the cover and
snap into place.
# 5SEAMEDIUMSIZEmATBLADESCREWDRIVERTOLOOSEN
the set screw in the crank handle.
D. Slide the crank handle onto the stud. Unlock, open
window, then close and lock window.
E. Fold the crank handle down and check alignment
of knob with the pocket.
Note: You may need to adjust the crank position
on the stud until the correct alignment is
achieved.
F. Open the crank and tighten the set screw.
'!FTERTHElNALINSTALLATIONFOLDTHECRANKOVERAND
snap the knob into the pocket.
Note: Even with the window open the crank can
be folded to avoid interfering with the window
treatments.
Crank Handle
C
D
Operator Stud
Set Screw
A
B
Pocket End
Operator Stud
Knob
E
Pocket
LOCK LEVER REMOVAL AND INSERTION
Note: You may want to remove the lock lever prior to finishing the window,
or if it needs to be replaced with a lock lever in a different finish.
A. Unlock and open the window.
B. Place the lock lever in the locked position.
# &ROMTHEEXTERIOROFTHEWINDOWINSERTASMALLmAT
blade screwdriver into the slot behind the lock lever.
D. Pry the cam away from the side of the window by
rotating the screwdriver a quarter turn.
Note: This will release the hook in the lever from
the cam hook.
E. Remove the lock lever by pulling it toward the
interior of the building.
F. To install a lock lever, hold it in the lock position
and insert it, from the interior, into the slot until it
snaps into the cam.
Interior
B
Exterior
C
Interior
F
Exterior
E
D