Caution
Failure to follow these instructions can damage the product or cause a hazardous
condition. Disconnect power during the installation of this product. All wiring must
conform to local codes and ordinances. This product is designed for use with 24
VAC systems.
For additional assistance visit www.PelicanWireless.com to request support.
Introduction
The plus50 provides a hardware upgrade to add CO
2
sensor capability to existing
Pelican thermostats including the TS200 and TS200H. Once installed, the
thermostat will provide continuous status of CO
2
levels and can provide demand
ventilation in three ways:
1. Control of the Pelican Pearl Economizer Controller.
2. In coordination with Pelican's line of Zone Controllers with integrated
Economizer Control.
3. Simple fan operation when CO
2
levels exceed the CO
2
set point.
Prerequisites
Existing Pelican thermostats will not recognize the CO
2
sensor unless they are
running at least firmware version 3.0. We recommend verifying the firmware version
before beginning installation. Contact Pelican Technical Support at
[email protected] or 888-512-0490 for assistance verify the firmware
version and if necessary to receive the free firmware upgrade.
Installation
The plus50 is provided as a replacement sub-base. The existing thermostat front
plate and internal Wiring Module (WM500 or WM700) will need to be installed into
the new sub-base. For installations where the Wiring Module has already been
relocated to a different location the new sub-base can replace the existing sub-base
without removing and re-installing the Wiring Module.
The installation steps are:
1. Turn off power to the thermostat.
2. Remove the existing front plate by pulling it straight away from the base.
3. Disconnect all control wiring.
4. Remove the existing Wiring Module as shown in the following section.
5. Remove the existing sub-base and install the new sub-base.
6. Re-install the Wiring Module into the new sub-base.
7. Reconnect control wiring. Re-install the thermostat front plate.
Installation Guide
PLUS50 integrated CO
2
Sensor
1
