Rev L —
Calcite pH Neutralizer
©
2019
Enviro Water Solutions, Inc.
3060 Performance Circle, Suite 2, DeLand, FL 32724
Page
10
IMPORTANT!
You will need to manually regenerate (
Regen Now
) your system prior to use. To do so follow the
programming below. You will not be able to use
water
for 20 minutes during this process.
1.
Using the DOWN button select
Manual Regen
and press SET.
2.
Using the UP or DOWN button select either
Regen Now
or
Regen Tonight
.
-
Regen Now
will start a regeneration process immediately.
-
Regen Tonight
will regenerate the system at the default regeneration time of 2:00am.
3.
Once selected press the SET button to confirm.
Gears will make noise and water will start to
flow. Allow the system to regenerate for approximately 20 minutes.
4.
Once
complete
press the MENU button to return to the main menu.
5. Your programming is now complete.
1. Press and hold the MENU button until you hear the beep to unlock.
2. Press MENU button for menu.
3. Press SET once
Date & Time Setting
is highlighted.
4. Using the UP and DOWN buttons input the correct Date and Time pressing SET after each input.
5. Once set press the MENU button to return to the main menu.
Programming the
Electronic Head
Note:
Power Source - For safety reasons the outlet must be protected by a Ground Fault Circuit
Interrupter (GFCI).
Your system is pre-set to regenerate every 3 days at 2
:00
am
,
the complete process takes 20 minutes
In the event of spikes in Iron and Manganese levels you may choose to manually regenerate your
system
if you experience colored water from your system.
S
tep 2: Performing a
Manual Regeneration
Notice:
Step 1: Setting the Date & Time
MENU
SET
(877) 842-1635
PelicanWater
.com
