background image

OPERATION

MAINTENANCE

II. REMOVING AND REINSTALLING/REPOSITIONING  

THE ALUMINUM RAILS

1. Remove all of the Drawers  

  (follow the procedure I).
2. Remove the 2 screws on each side 

  using a #2 Phillips head screwdriver.
3. Remove the Side Plate/Rail Assembly 

  by pulling it forward out of the case. 
4. Remove the Aluminum Rails from the  

  Side Plates by depressing the tab(s)  

  at the back of the plastic side plates 

  and sliding the rails rearward.

3

2

1

4

4

5. Reinstall the Aluminum Rails into the Side Plates in the desired position by sliding 

  the rails into the side plates from the back. 
  NOTE: The right-hand aluminum rails are different than the left-hand  

  aluminum rails, so care should be taken not to mix them up. 
6. Once all the aluminum rails are installed into the side plates, slide the side plate 

  back into the case and re-install the 2 screws using a hand screwdriver, taking  

  care not to over-tighten the screws. 
  DO NOT USE A POWER SCREWDRIVER.

NOTE: Wheels can be replaced without removing the entire trolley assembly.
To replace a broken wheel, remove the Lock Nut on the end of the Axle, using a 

7/16" open end wrench on the Lock Nut and a 5/16" open end wrench on the Axle. 

Slide the Axle out. Remove wheel and reinstall new wheel.

V. WHEELS

· It is recommended that the Slide/Rail System be lubricated prior to initial use,  

  and cleaned and lubricated every 500 cycles during use.
· In addition, periodically inspect the drawer/slide system for debris and clean  

  as needed, especially during periods of heavy usage.
· The Slide/Rail system can be cleaned by removing the Drawers and/or removing  

  the entire Side Plate/Rail Assembly (follow the procedures above). 
· Clean any debris out of the system using a brush or compressed air.
· Lubricate the Side Plates, Metal Rails, and Drawer sides with dry-film PTFE spray, 

  silicone lubricant, or light-weight oil.

III. DRAWER SLIDE/RAIL SYSTEM

To maintain a watertight seal, the 

O-Ring Gaskets must be kept clean of 

dirt and debris. If the O-Ring becomes 

cut or cracked, it must be replaced.

IV. O-RING GASKETS

Reviews: