Pelgrim PFI8160WIT, Instructions For Use Manual

Page: 61 / 68

EN 29
Symptom Possible cause Solution
Error code E3. Unsuitable pan used. Use a pan suitable for induction
cooking.
Error code E2. Appliance over heated. The appliance has been switched
off because of over heating.
Fault code E6. The appliance has been connected
incorrectly and/or the mains
voltage is too high. Have your connection changed.
The fuse in the appliance will blow
if all 4 cooking zones are used on
a high power level. Appliance is connected to a 2
phase network and not adjusted to
"Lo" by software. Set the appliance to "Lo"
(power limiter).
Zone(s) don't work or don't heat up
sufficiently. Appliance is connected to a
2 phase network and not adjusted
to “Lo” by software. The appliance's inbuilt power
limiter limits the maximum power
that can be used simultaneously.
Other fault codes. Defective generator. Contact the service department.
Oven
• The food is not cooked
▷ Check whether the timer has been set and you have pressed the ‘start button’.
▷ Close the door properly.
▷ Check whether a fuse has blown and whether a circuit breaker has been activated.
• Food is overcooked or undercooked
▷ Check whether the correct cooking time has been set.
▷ Check whether the temperature has been set.
• The display will be reset following power failure
▷ Remove the plug from the socket and put it back in again.
▷ Set the time again.
• There is condensation on the interior of the oven
▷ This is normal. Wipe the oven clean after use.
• The fan keeps working after the oven is switched off
▷ This is normal. Once the oven has been switched off, the cooling fan may continue to
run for a little while.
• Air flow can be felt at the door and the exterior of the appliance
▷ This is normal.
• Light reflects on the door and the exterior of the appliance
▷ This is normal.
• Steam escapes from the door or the vents
▷ This is normal.
• Clicking sounds can be heard when the oven is working, particularly in the defrost
setting
▷ This is normal.
SOLVING PROBLEMS