96-500 Sochaczew, ul. 15-go Sierpnia 33a
NIP: 837-135-72-55, Regon: 140146548
tel./fax +48 46 862 34 88, tel. 48 513 153 944
Credit Agricole Bank Polska S.A.
tel./fax +48 22 379 79 44 www.peiter.pl, [email protected]
19 1940 1076 5239 5305 0000 0000
www.peiter.pl
www.peiter.pl
3.
Place the original remote control to be programmed in front of the ArtMatic, at about 5 cm of distance.
4.
Press and retain pressed the button to be programmed of the original remote control, till the LED will
switch on as a fix light; now release the button.
5.
The ArtMatic LED will emit a short flash every 2 seconds. This alert informs the user that, to duplicate
the remote control, it is necessary to emit the SEED CODE to realize the copy.
6.
Predispose the FAAC/GENIUS remote control for the SEED CODE emission. Press at the same time
the 1 and 2 buttons (note: THESE ARE THE BUTTONS OF THE DIAGONAL LINE as in the picture).
7.
While FAAC/GENIUS remote control LED flashes, place it in front of
ArtMatic at a distance of 5 cm and press the button to be programmed
until the ArtMatic LED will change the flash mode (more fast). This step
may take some seconds.
8.
At this moment, press the button when you want to store the code and
retain pressed until the ArtMatic LED switches off.
9.
The copy has been happened with success. Now check on the
automation the correct functioning of new ArtMatic
remote control pressing two times the copied button.
Notes:
• The ArtMatic memory is completely re-writable.
• To duplicate further buttons of ArtMatic, please repeat the operation from the step 1.
ARTMATIC TO ARTMATIC DUPLICATING PROCEDURES
1.
While pressing the button 1 of the “NEW ArtMatic”, at the same time press 4 times the 2 button.
2.
Release both buttons. Now the LED of “NEW ArtMatic” will emit a short flash every 2 seconds.
3.
Place the “SOURCE ArtMatic” in front of the “NEW ArtMatic”, at about 5 cm of distance (as in the
picture at the page 1).
4.
Press and retain pressed the button to be programmed of the “SOURCE ArtMatic”
NOW IF THE CODE IN THE “SOURCE ARTMATIC”
IS A FIXED
OR ROLLING-SIMPLE CODE
IS A ROLLING-COMPLEX CODE
5a
wait for a change flash (as a faster flash) of
“NEW ArtMatic” LED that confirms the correct
learning of code. This operation may take some
seconds.
5b
The ArtMatic LED will emit a short flash every
2 seconds. This alert informs the user that, to
duplicate the remote control, it is necessary to emit
the SEED CODE to realize the copy.
