GB - 1
20-FU-BLS (Rev03_080902)
Paul Hochköpper GmbH & Co. KG
Postfach 1727 • D-58467 Lüdenscheid • Tel.: +49 (0)2351 185-0 • Fax: +49 (0)2351 27666 • e-mail: [email protected] • Internet: www.peha.de
Installation and operating instructions
Easyclick wall transmitter
EDV-Nr.: 31060000-152
The following variations of transmitters are available:
The following accessory is needed for the installation:
The transmitters are to be completed with the 1 to 5 combination frames of the
according PEHA switch programme.
The combination frames have to be ordered separately!
1.1 Application
The wall transmitters are part of the PEHA radio system. The
radio transmission takes place at the European harmonised fre-
quency of 868.3 MHz. It is particularly suitable for areas where
no repairs are required, such as renovations, retrofitting of elec-
trical systems or offices with mobile walls.
By pressing a button,
consumers can be switched wirelessly through receivers.
The transmitters must be assigned to the receivers.
Therefore,
refer to the receivers operating instructions. Every wall transmit-
ter can control an indefinite number of receivers.
Notes:
– The wall transmitters function without batteries and are
maintenance-free !
– Read through the operating instructions carefully before
putting the device into service.
1.2 Warranty conditions
These operating instructions are an integral part of both the device and our terms of
warranty. They must be handed over to the user. The technical design of the appli-
ance is subject to change without prior notification.
PEHA
products are manufactured
and quality-checked with the latest technology according to applicable national and
international regulations. Nevertheless, if a product should exhibit a defect,
PEHA
warrants to make remedy as follows (regardless of any claims against the dealer to
which the end-user may be entitled as a result of the sales transaction):
In the event of a justified and properly-established claim,
PEHA
shall exercise its
prerogative to either repair or replace the defective device. Further claims or liability
for consequential damage are explicitly excluded. A justifiable deficiency is one in
which the device exhibits a structural, manufacturing, or material defect that makes it
unusable or substantially impairs its utility at the time it is turned over to the end-user.
The warranty does not apply to natural wear, unintended usage, incorrect connection,
device tampering or the effects of external influences.
The warranty period is for 24 months from the date of purchase by the end-user from
a dealer and ends not later than 36 months after the device’s date of manufacture.
German law shall be applicable for the settlement of warranty claims.
1.3 Disposal of the device
The device must be disposed of in compliance with the laws and standards of the
country in which it is operated!
This device is only intended to be used for its stated application. Unauthorised conver-
sions, modifications or changes are not permissible! This device may not be used in
conjunction with other devices whose operation could present a hazard to persons,
animals or property.
The following must be observed:
• Prevailing statutes, standards and regulations.
• State-of-the-art technology at the time of installation.
• The device’s operating instructions.
• Operating instructions can only cite general stipulations. These are to be viewed in
the context of a specific system.
Note:
The strength of the radio signal between sender and receiver decreases with
increasing distance. The visually unobstructed range is about 30 m in passageways
and 100 m in open rooms. The range can be increased through the use of an Easy-
click repeater (453 FU RP).
GB
1. General
2. Safety
3. Technical specifications
4. Structure and description
95.450.xx
95.455.xx
Retaining plate
Wall transmitter in Dialog-Design
20.450.xx
20.455.xx
Retaining plate
Wall transmitter in Aura-Design
Latches
80.450.xx
80.455.xx
Retaining plate
Wall transmitter in Standard-Design
250.xx
255.xx
Retaining plate
Wall transmitter System Modul 45
Latches
Latches
Latches
When having a
2-button function:
O = OFF
I = ON
r
= UP
q
= DOWN
Variations
Symbols
Descriptions
FU-BLS
O
I
OFF
ON
FU-BLS JR
r
q
UP
DOWN
FU-BLS N
—
neutral
(without label)
General data
Operating fequency
868.3 MHZ
Transmission power
10 mW
Modulation type
(ASK Amplitude Shift Keying)
Cycles of operation
min. 50,000
Operating temperature
-25°C to +65°C in dry rooms
Relative humidity
0% to 95 %
Range in buildings
Masonry
20m (max. 3 walls)
Reinforced concrete
10m (max. 1 wall/ceiling)
Drywall/wood
30m (max. 5 walls)
