Pegasus FS700 Series, Instruction Manual

Page: 7 / 36

● Always turn off the power before performing the procedures
shown below.
・
Adjusting the stitch length
・ Adjusting the differential feed ratio
● Only well-trained people should perform routine daily
maintenance and/or repair the machine.
● Do not modify the machine yourself.
※ Consult your local Pegasus' sales office or representative for
modification.
(2)Before operating the machine
● Check the machine head and unit for any damage and/or faulty
function at the start of each day.
If there should be something wrong with the machine,
immediately perform repairs and/or other necessary procedures.
● Check by hand to see if the needle holder is secured.
※ Be careful of the needle point.
● Before starting the machine, make sure that the presser foot is
positioned correctly (turn the machine pulley slowly by hand to
see if the needle point is centered in the needle drop hole on the
presser foot).
● Check to see if the presser foot is secured (raise the presser foot
by the foot lifter and press it by hand front to back and left to
right).
(3)Training
● To prevent accidents, operators and service/maintenance
personnel should have proper knowledge and skills for safe
operation.
To ensure so, managers must design and conduct training for
these people.
4.Notes for each procedure
CA
CA
UTION
UTION
①
Unpacking
1.The machine is packaged in a cardboard box before shipping.
Unpack your machine in orderly sequence while checking them
right-side up by referring to the indications, such as logo, etc.
printed on the boxes.
2.Never hold the area near the needle and/or thread guide related
parts when taking out the machine from the cushion.
Otherwise it may cause injury and/or damage to the machine.
3.Take out the machine very carefully while checking the position of
the center of the gravity.
4.Keep the cardboard box and packing carefully in case secondary
transport is needed in the future.
Disposal of the packaging
● The packaging material of the machine consists of wood, paper,
cardboard and VCE fiber. The proper disposal of the packaging
is the responsibility of the customer.
Disposal of machine waste
1.The proper disposal of machine waste is the responsibility of the
customer.
2.The materials used on the machines are steel, aluminum, brass
and various plastics.
3.The machine waste is to be disposed of in accordance with the
locally valid environmental protection regulations. A specialist
should be commissioned if necessary.
※ The parts contaminated with lubricants should be disposed off
separately according to the locally valid environmental protection
regulations.
Transport within the customer's premises
●
The manufacturer assumes no liability for transport within the
customer's premises. Care should be taken to transport the
machine in an upright position avoiding it from dropping or falling
down to the ground when it is moved.
4
From the library of: Superior Sewing Machine & Supply LLC