19 Pegasus Astro
– Copyright 2021
The “gear mesh” icon below
will notify you that the backlash compensation functionality is enabled.
Position Limits
You can set the maximum & minimum step position that the motor can go. This will enforce the controller to
disallow a motor move to the direction you are about to exceed this limit. This is a handy option to prevent the
focuser to fully move in or out.
•
Move to the
Settings
tab and type the numeric limit inside the “Minimum” and “Maximum” field.
•
Click the “ON” to enable these limits.
When you try to exceed this limit the controller will deny to increase steps and it will notify you that the limit
was about to exceed.
Disabled Knob of the Hand Controller
If you would like to disable knob on the side of the controller
•
Press the knob for two (2) seconds.
•
You can also disable it from the settings of the standalone software.
Hand Controller’s both leds will turn on
and the software will report the disabled status of the knob.
