11
3. Install Anemometer Cups
Plug each cup firmly into place on the anemometer rotor
housing. Be sure that each cup arm snaps solidly.
NOTE: THE CUPS MUST BE ORIENTED AS SHOWN OR
WIND DIRECTION WILL BE INCORRECTLY DISPLAYED,
AND THE CUPS WILL NOT PROPERLY LOCK INTO
PLACE.
CUP ORIENTATION
(viewed from above)
4. Install Cup Retaining Clips (PRO Anemometer Only)
Spread the metal retaining clip apart and over the top of each
cup connection as shown.
Press down until clip is FULLY seated. Press the sides of the
clip to be sure the clip wraps around the bottom side of the cup
connection.
12
5. Install the Wind
Vane Fin
Insert the fin into the
open end of the
wind vane pointer
as shown. Press in
firmly until a “snap”
is felt.
6. Select the correct Anemometer Calibration
The correct anemometer (PRO, w/2.6” cups, or Standard, w/1.2”
cups) must be selected on the
ULTIMETER
keyboard/display for
wind speed to be properly calculated and displayed.
a. Press
and
buttons simultaneously to display the
presently selected anemometer. The default setting is “PRO”.
b. To change setting between “PRO” anemometer and “Std”
anemometer, press and HOLD
and
buttons
simultaneously while the display flashes three times. The new
selection is then displayed.
c. Press any key to return to normal operation.
d. Displayed wind speeds using PRO calibration will include
tenths of units (ex: 10.5), where wind speeds using Std
calibration will be display as whole numbers (ex: 10).
