PEERLESS Solid-Point PLCM UN1 Installation And Assembly Manual Download Page 2

ISSUED:09-08-07    SHEET #: 202-9199-1

Visit the Peerless Web Site at www.peerlessmounts.com

For customer care call 1-800-729-0307 or 708-865-8870.

2 of 9

• Do not begin to install your Peerless product until you have read and understood the instructions and warnings

contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, please
call Peerless customer care at 1-800-729-0307.

• This product should only be installed by someone of good mechanical aptitude, and fully understands

these instructions.

• Never exceed the Maximum UL Load Capacity.

• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.

• Tighten screws firmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding

power.

• Installer must verify that the ceiling will safely support the combined weight of all attached equipment and hardware.

WARNING

Table of Contents

Parts List .............................................................................................................................................................................. 3

Installing Ceiling Plate (model PLCM-UN1-CP only) .............................................................................................................. 4

Installing Flat Panel Straight Column Mount to ceiling .......................................................................................................... 5

Installing Adapter Plate ......................................................................................................................................................... 6

Installing Adapter Plate to Screen ..................................................................................................................................... 7, 8

Installation of Screen to Flat Panel Straight Column Mount .................................................................................................. 9

Summary of Contents for Solid-Point PLCM UN1










Reviews: