ISSUED: 09-10-07 SHEET #: 090-9130-7 07-06-09
Visit the Peerless Web Site at www.peerlessmounts.com
For customer care call 1-800-729-0307 or 708-865-8870.
5 of 8
NOTE: Adapter plate support box (D) can be flipped either way to allow necessary screen clearance. For best results,
have screen close to desktop but not touching.
Adapter plate support box (D) is adjustable up to 6" at 1" increments. Attach adapter plate support box (D) to support
tube (A) as shown in fig 7.1, then fasten two 1/4-20 x 1/2" phillips screws (H) and two split washers (G) through
adapter plate support box (D) and support tube (A), as shown in fig. 7.2.
fig. 7.1
A
D
fig. 7.2
H
D
SUPPORTING SURFACE NOT SHOWN FOR CLARITY
7
Line up base assembly (step 5), through supporting surface with pattern of
base (C) facing the front as shown in Detail 1. Using four fender washers (V)
and four lock nuts (N) tighten in numbered pattern as shown in Figure 6.1. At
minimum 1/4 - 20 locknuts (N) should be flush with bottom of threaded rods
(L or M) and no less than. For added security replace two of the washers and
locknuts with slope nuts. Hand tighten slope nuts (W) onto two of the thread
rods (L or M) till snug against bottom of table as shown in Figure 6.2. Thread
another slope nut (W) upside-down, about two turns from first slope nut (S) as
shown in Detail 2. Insert a 5/8
"
open box wrench between both slope nuts (W)
and tighten. NOTE: Avoid jamming both slope nuts (W) together, doing so
may make it difficult to remove slope nut used for tightening. After slope nut
is secure remove bottom slope nut.
NOTE: If enhanced security is desired, use two drops of loc-tite 271 thread
lock adhesive (P) on the threads of each 1/4 - 20 locknut (N).
6
5
Line up backer plate (B) with
threaded rods (L or M).
NOTE: Washer (F) must be
centered
B
L or M
fig. 5.1
Detail 2
fig. 6.1
A
C
SUPPORTING
SURFACE
FRONT
BOTTOM OF TABLE
W
TIGHTENING
SLOPE
NUT
2
3
1
4
fig. 6.2
CAUTION
• Installations to desktops that have a
gap between two supporting boards
are not acceptable mounting
surfaces for the HP line of desktop
swivel mounts.
V
FRONT OF
SCREEN
Detail 1
C
• Make sure that the supporting surface will safely support the combined load of the equipment and all attached
hardware and components
WARNING
F
N
G
