ISSUED: 09-10-07 SHEET #: 090-9130-7 07-06-09
Visit the Peerless Web Site at www.peerlessmounts.com
For customer care call 1-800-729-0307 or 708-865-8870.
4 of 8
• Wooden mounting surface requires a minimum of 3/4" thickness to hold screen securely
WARNING
Turn base (C) upside down insert support tube (A), and
thrust washer (F) as shown below.
If the desk thickness is between 3/4" to 1" use
1/4-20 x 1.5" threaded rods (L). If the desk thickness
is between 3/4" to 2-3/8" use 1/4-20 x 3" threaded
rods (M). Turn base (C) upside down and insert four
threaded rods (L or M) into base (C), as shown in
figure 2.1.
NOTE: Threaded rods must fasten a minimum of
three turns.
NOTE: If enhanced security is desired, use three
drops of loc-tite 271 thread lock adhesive (P) along
1/4" at the end of each threaded rod. Insert adhesive
end of threaded rods (L or M) into bottom of base (C).
A
C
F
fig. 3.1
2
3
L or M
C
fig. 2.1
Refer to fig. 4.1 and 4.2, select the desired swivel degree. Using a 3/32" allen wrench, fasten two set screws (K) where
indicated below to the outside of desired angle in steel base (C).
NOTE: Set screws (K) must be bottomed out into base.
Swivel Restriction
4
fig. 4.1
fig. 4.2
60°
120°
LOCK AT 0°
C
A
180°
240°
240°
210°
40°
30°
30°
210°
