8 of 34
ISSUED: 03-26-10 SHEET #: 095-9345-5 11-02-11
If more or less tension is desired in the arm pivot points, do the following:
• To increase tension, turn socket screw clockwise with 5mm allen wrench (
I
).
NOTE: Tighten screws to
50 in • lbs (5.6 N.m.) maximum torque.
• To reduce tension, turn socket screw counter-clockwise with 5mm allen wrench (
I
).
NOTE: Do not turn more
than half a turn.
© 2011, Peerless Industries, Inc. All rights reserved.
All other brand and product names are trademarks or registered trademarks of their respective owners.
Cable Management
NOTE:
Make sure cables have enough slack to allow full movement of the arm.
Run power cable through top or bottom of arm (
A
) and signal cable(s) through other side of arm in order to avoid
interference with the signal. Lock cables into place by snapping cable covers (
J & B
) onto mount. Display may have
to be moved for easy access.
Optional:
If additional cable management is required route cable ties (
G
) through slots of arm (
A
) as shown in
detail 2.
5
6
A
G
B
J
CABLE
TENSION SCREWS
TENSION SCREW
DETAIL 2
SLOT
• Do not remove screw or loosen screw until it is no longer engaged with the mount. Doing so may cause the display
to fall.
• If screws become loose over time, tighten screws as necessary. Tighten screws to 50 in • lbs (5.6 N.m.) maximum
torque.
WARNING
