7 of 41
ISSUED: 06-05-06 SHEET #: 202-9140-9 06-14-12
Snap four cable management clips (
R
) into top or bottom of arm assembly (
C
) as shown
.
Cable ties (
S
) are used
with clips for cord management.
Slide one mesh sleeve (
T
) over each cable. Use cable ties (
S
) to tighten mesh sleeves to cables.
NOTE: There are fi ve mounting positions.
The center position is shown (right).
Slide
washer (
J
) over wall support arm axle (
D
).
Next, insert plastic cap (
N
) into axle. Then,
insert holding pin (
M
) into axle. See detail 1.
R
S
C
2
3
T
3-1
Insert socket cap screw (
K
) into hole at bottom
of wall support arm axle (
D
) as shown in detail
3. Tighten screw using 9/64" allen wrench (
Q
).
NOTE:
Fit of axle (
D
) into wall plate (
A
) and
arm assembly (
C
) will be tight. Gently tap into
place with a hammer if necessary.
N
J
D
M
J
C
DETAIL 1
Place arm assembly (
C
) with washer (
J
) into
wall plate (
A
). Insert axle assembly shown in
detail 1 through wall plate (
A
), arm assembly
(
C
), and washer (
J
). Lock axle in place by
aligning holding pin (
M
) with notches shown in
detail 2.
2-2
NOTCH
DETAIL 2
• If you are uncertain that product is properly installed, call customer care.
WARNING
K
D
DETAIL 3
2-1
A