background image

ISSUED: 01-30-07  SHEET #: 009-9037-1

Visit the Peerless Web Site at www.peerlessmounts.com

For customer care call 1-800-729-0307 or 708-865-8870.

of 

4

Parts List

DESCRIPTION

QTY.

A

tri-bar belt clip

2

B

belt guides

2

C

belt with cinch buckle

1

D

belt without buckle

1

E

   clear strips

2

D

C

A

E

B

Begin by connecting belt with buckle 

(C) 

to belt without buckle 

(D).

C

C

D

D

B

A

A

B

Continue by sliding on one belt guide (

B

) and one tri-bar belt clip (

A

) on each side of the buckle. Refer to drawing

below.

A

TOP

BOTTOM

NOTE LINES
FACES UP

Model: ACC 316

Some parts may appear slightly different than illustrated.

Installation & Assembly - Safety Belt

Summary of Contents for ACC 316

Page 1: ... C belt with cinch buckle 1 D belt without buckle 1 E clear strips 2 D C A E B Begin by connecting belt with buckle C to belt without buckle D C C D D B A A B Continue by sliding on one belt guide B and one tri bar belt clip A on each side of the buckle Refer to drawing below A TOP BOTTOM NOTE LINES FACES UP Model ACC316 Some parts may appear slightly different than illustrated Installation Assemb...

Page 2: ...te keep buckle closer to left side of the electronic component to allow for movement when tightening belt assembly Trim off the end of the belt if necessary then lightly burn the end of the belt to prevent fraying Repeat step 3 for the other side of the electronic component 6 A B Make sure that electronic component surface is clean of grease oil and dust Once all components are in place remove sti...

Page 3: ... sure that front bottom edge of electronic component is positioned behind and against the front lip of the tray This will prevent electronic component from sliding forward on the tray Take one belt C or D and hold it so that the tri bar belt clip A is facing as illustrated Feed belt C or D up through the slot you have chosen Remember belt only goes through outside slot Now feed belt C or D through...

Page 4: ...f 4 The safety belt provided with your mount is designed to stabilize the electronic component on the mounting tray It is the responsibility of the installer to ensure the stability of the television by purposefully pushing the electronic component in all directions to test the installation WARNING Tighten belt by pulling on loose end LOOSE END ...

Reviews: