O
PERATION
Combination Warmer
▪
Operator’s Manual
▪
M N-47320
▪
Rev 1
▪
1/21
22
How to Operate the Fluid Warmer
Before you begin
The warmer must be connected to electric power and turned on.
Procedure
To operate the warmer, do the following.
Step
Action
1.
Select
the operation mode.
▪
Press
the irrigation button
for irrigation mode.
▪
Press
the injection button
for injection mode.
To change between irrigation mode and injection mode, turn the screen off
and then back on.
2.
Set
the temperature using the arrow buttons
.
Continued on next page
WARNING:
Personal injury hazard.
Do not operate the warmer in the presence of a flammable
anesthetic mixture with air, oxygen, or nitrous oxide; in
oxygen-enriched environments; or in any other potentially
explosive environment.
WARNING:
Personal injury hazard.
Verify the fluid temperature prior to using the fluid. Refer to the
fluid manufacturer’s label for recommended warming
procedures.
Do not use any fluids that are warmed above the suggested
temperature.
NOTICE
Do not overload the cavity.
Refer to topic
Specification Information
for the storage cavity
capacity.
NOTE:
Open the door to cool the cavity before changing
from a higher temperature to a lower temperature.
NOTE:
The irrigation temperature set-point range is
98°F – 150°F (37°C – 66°C).
The injection temperature set-point range is 98°F – 104°F
(37°C – 40°C).
Summary of Contents for P-2140
Page 1: ...Operator s Manual Combination Blanket Fluid Warmer P 2140 MN 47320 REV 01 1 21 EN ...
Page 38: ......
Page 39: ......
