Pecol V 20 Brushless RBPROHP, Manual, Page: 64 / 92

P. 64
PT ES EN FR
4.5. Troubleshooting Chart
In case of problems not mentioned or of problems that you can not solve, contact our
Technical Assistance Service PECOL (page 63).
PROBLEM POSSIBLE CAUSE SOLUTION
The tool will not start or
suddenly stops
Battery is discharged.
Check level, if the level light indicates
only red, recharge the battery by
carefully following the instructions on
page 56 to 58. Do not insist on use until
it is recharged.
Battery out of temperature range.
Wait for the battery temperature to
normalise.
Electronic overload protection
triggered.
Switch off the machine by the trigger,
correct working conditions and switch
on again. Avoid constant protection
activation.
Switch damaged.
Refer to PECOL Technical Assistance
Service.
The charger does not charge or
does not work
Power cable or extension cord (if
applicable) broken.
If the power cable of the charger is
damaged, it must be replaced. If it is a
defective extension, replace it.
Charger did not stabilise.
Wait for 2 or 3 minutes. If it persists,
remove the battery, unplug the
charger, check the cleaning and
tightening of the contacts, and try
again. If it still persists, call PECOL
Technical Assistance Service.
Battery outside the allowed
temperature range 5°C to 40°C
(Red light flashing).
Faulty battery (green and red
lights flashing).
Refer to PECOL Technical Assistance
Service.
Charger broken (lights do not
light up).
Low performance of the tool
Thermal protection of the
activated battery
Wait for the battery temperature to
normalise.
The tool body or battery
becomes too hot
Machine in overload.
Decrease working pressure. Turn
on the machine in dry run for 2 to 3
minutes to cool the engine. Or stop
and wait for the battery to cool down.
Lack of ventilation. Unclog the air passages.
Bearings damaged.
Refer to PECOL Technical Assistance
Service for replacement.
Gearbox heats too much
Lack of lubricant /
lubricant deteriorated. Refer to PECOL Technical Assistance
Service.