Peco 28621206, Operator'S Manual

Page: 7 / 20

2-8 Engine Mount Arm Installation
Insert the engine mount arm P#(A0318) into the outer
motor mount tube P#(B1117) and fasten with (1) detent
pin P#(J0248). See Figure 2-8.
2-9 Engine/Blower/Blade Assembly
Installation
Place the engine/blower/blade assembly onto the engine
mount arm assembly P#(A0318). Secure the
engine/blower/blade assembly to the engine mount arm
assembly using (4) 5/16”-18 x 1-1/2” HHCS P#(K1157)
and (4) 5/16”-18 flange nuts P#(K1178). See Figure 2-9.
9
2-6 Dump Mechanism Adjustment
The linkage may be adjusted in two places, at the
adjusting screw P#(K1435) and the latch assembly
items. See page 10 for visual clarification. To change the
door closure tightness, screw the adjusting screw
(Figure 2-6.) in or out. To adjust the latch, change the
length of the latch rod by screwing the latch adjusting
ball joint in or out. The latch hook pivot should be in the
middle of the slot in the latch hook pivot plate. Slide the
pivot back or forth and then re-tighten.
2-7 Outer Engine Mount Tube
Installation
Attach the outer engine mount tube P#(B3727) to the
mount bracket assembly P#(A0257) using (2) 3/8”-16 x
3” u-bolts P#(K1432) and (4) 3/8”-16 flange nuts
P#(K1215). See Figure 2-7.
7
Adjusting Screw
Cotter Pin
Figure 2-6.
Figure 2-7.
Outer Engine
Mount Tube
Mount Bracket
Figure 2-8.
Engine
Mount Arm Detent Pin
Outer Motor Mount Tube
Figure 2-9.
Engine Mount
Arm Assembly
(4) 5/16”-18 x 1-1/2” HHCS
(4) 5/16”-18 Flange Nuts
Engine/Blower/Blade
Assembly
(2) U-Bolts
(4) Flange Nuts