Peco 28621206, Operator'S Manual

Page: 13 / 20

2-16 Lower Hose To Boot Installation
Take the unattached end of the lower hose and slide it
over the circular end of the boot. Use the lower hose
clamp to secure the hose to the boot (Figure 2-16.).
Before securing the clamp, rotate the hose counter-
clockwise (away from yourself) approximately 1” to aid in
retaining boot to mower deck.
2-17 Weight Bracket Installation
Fasten the weight bracket to the wheel frame using (1)
1/2”-13 x 4” x 2-1/2” u-bolt P#(K1101) and (2) 1/2”-13
flange nuts P#(K1246) PER SIDE. Fasten the weight to
the weight bracket using (2) 1/2”-13 x 4-1/4” x 4-5/16” u-
bolts P#(K0331) and (4) 1/2”-13 flange nuts P#(K1246)
PER SIDE. See Figure 2-17.
9
2-12 Boot To Mower Deck Installation
Fasten the boot plate P#(B0125) to the boot P#(E1128)
using (2) 3/8”-16 x 1” carriage bolts P#(K1182) and (2)
3/8”-16 flange nuts P#(K1215). Remove the deflector
pin that attaches the grass deflector to the mower deck.
Mount the boot plate to the mower deck using the
deflector pin as shown in Figure 2-12.
2-13 Length Of Hose Adjustment
The hoses in steps 2-14. and 2-15. must be cut to fit
your machine. Follow steps 2-14. and 2-15. Do not cut
the hoses until you have tried to fit them on your
machine. Keep in mind that the hoses have to be long
enough to adjust for the blower assembly’s movement
as well as allow for enough clamping surface between
the inlet, blower assembly, and the deck boot.
2-14 Upper Hose Installation
Slide a 5”-6” upper hose clamp P#(J6011) onto both
ends of the 6” upper hose (Figure 2-15.) Then slide on
end of the 6” hose onto the inlet. Make sure there is at
least a two-inch overlap between the hose end and the
container inlet. Slide the opposite end of the 6” hose
onto the outlet of the blower assembly (Figure 2-15.)
Make sure both ends of the hose are securely attached
to the inlet and the blower assembly and then tighten the
hose clamps.
2-15 Lower Hose To Blower Cone
installation
Slide a 7”-8” hose clamp P#(J6006) over both ends of
the lower hose. Then slide the lower hose onto the
blower cone. Tighten the hose clamp. The assembly
should look like Figure 2-15.
13
Figure 2-12.
Deflector Pin Boot Plate
(2) 3/8”-16 x 1”
Carriage Bolts &
(2) 3/8”-16 Flange Nuts
Figure 2-15.
Inlet
5”-6”
Clamp
7”-8”
Clamp
Blower
Cone
Lower
Hose
Boot
Upper
Hose
Figure 2-16.
Figure 2-17.
Boot
Lower Hose
7”-8” Clamp
Weight
Weight
Bracket
Wheel Frame