2-8 Upper Frame Assembly
Installation
Lift the upper frame assembly P#(A1838) into position
above the lower mount assembly. Insert the vertical tube
on the lower mount assembly into the vertical tube on
the upper frame assembly. Secure the upper frame
assembly using (1) clevis pin P#(K0133) and (1) hair pin
clip P#(K0088). Refer to Figure 2-9.
2-9 Top Assembly To Upper Frame
Assembly Installation & Inlet
Installation
Position the top assembly P#(A1157) above the upper
frame assembly as shown in Figure 2-9. Fasten the top
assembly to the upper frame assembly using (2) 5/16”-
18 x 2-1/2” HHCS P#(K0125) and (2) 5/16”-18 nylon
flange locknuts P#(K2516). Leave the locknuts slightly
loose, to allow the top assembly to open and close
easily. Refer to Figure 2-9 for hardware location.
From the inside of the top assembly, slide the inlet
P#(V0025) into the hole on the bagger top until the inlet
locks into place. The inlet should pivot 360 degrees
about the hole in the bagger top. Refer to Figure 2-9.
8
Figure 2-9
5/16”-18 x 2-1/2”
Hex Bolt
5/16”-18
Locknut
Upper Frame
Assembly
Top
Assembly
Insert Inlet
From Inside
Inlet
Clevis
Pin
Hair Pin
Clip
5/16”-18 x 2-1/2”
Hex Bolt