12
2-11 Aluminum Grass Container
Installation
NOTE:
It is recommended that (3) people assist in
mounting the container. With three people available, two
can lower the container onto the frame while the third
person inserts the pivot pins P#(K0172) through the
holes as shown in Figure 2-11a. Insert the pins from the
outside to the inside. Secure with (1) 5/8” washer
P#(K0058) and (1) 5/32” x 2-5/8” hair pin clip P#(K0088)
per pivot pin (Figure 2-11b). Reattach the bottom ends of
the door opening linkages to the main frame by using (1)
Rue-Ring cotter pin P#(K1437) per side. To test the
functionality of the dump mechanism, pull the lift handle
away from the unit, and lift upward. The door of the
container should open and the box should pivot
clockwise towards the ground.
2-12 Dump Mechanism Adjustment
The linkage may be adjusted in two places, at the
adjusting screw P#(K1435) and the latch assembly
items. See page 20 for visual clarification. To change the
door closure tightness, screw the adjusting screw
(Figure 2-12) in or out. To adjust the latch, change the
length of the latch rod by screwing the latch adjusting
ball joint in or out. The latch hook pivot should be in the
middle of the slot in the latch hook pivot plate. Slide the
pivot back or forth and then re-tighten.
Rue-Ring
Cotter Pin
Adjustment
Screw
Figure 2-12
Attach
Here
Figure 2-11a
Box Assembly
Figure 2-11b
Washer
Hair Pin
Clip
Pivot
Pin
