PEBCO Dustless Loading Spouts, Manual

Page: 14 / 35

PEBCO®
DUSTLESS LOADING/SELF-CONTAINED DUSTLESS LOADING SPOUTS GENERAL INSTALLATION
11
Figure 1 : Cone Assembly Placement
(a) Cone Support Tabs
(b) Discharge Cone
(a)
(b)
•
Cone assembly, including cone support cable harness
•
Outer flexible sleeve
•
Miscellaneous parts including: fasteners, cable fittings, and other items as identified on
the parts list or packing list.
Installation and assembly of the unit is completed as follows:
1. Remove the bolts and straps holding the DLS in the shipping frame.
2. Check the alignment of the bolt holes on the housing assembly to determine if the
bolt holes will match correctly. Do not attempt to correct alignment by drilling through
the flange, as this will possibly weaken the flange and result in a poor seal. Check the
mating flange for level.
3. Install the appropriate gasket material or sealant on the top flange surface of the
housing assembly.
4. Using a fork truck or other appropriate equipment, lift the housing assembly to the
mating flange.
5. Install nuts and washers. Use only a high grade hex head bolt with an equal grade of
nut, flat and lock washer. Lock washers and/or a thread locking material should be
used. Angle supports on top of the housing assembly must be utilized for additional
support to the hopper or other rigid steel structure to ensure that the housing assembly
is installed securely; the unit CANNOT be supported solely by the flange.
6. Install the dust collection hose/pipe to the side outlet of the housing using an appropriate
gasket material. (Not necessary for SCDLS units)
7. Position the outlet assembly
beneath the housing assembly at
the published extended length.
The junction box for the product
sensor probes, if provided, should
be aligned with the junction box
for that purpose on the housing
assembly. Align the lift cable
attachment points on discharge
with the sheaves in the housing
assembly.
8. Place the cone assembly in the
discharge cone as shown in
Figure 1 , aligning the cone
support tabs with tabs on
discharge cone. Attach the cone
support cables to the discharge
cone.