20
18
18
24
25
21
22
26
28
23
Front Panel: Lower
Front Panel: Upper
(10) Tape/CD to Control Room
Pressing this switch adds the tape/cd input signal to the control room (23) and headphone outputs (22).
(11) Headphone/Control Room Level
This knob sets the headphone and control room output levels. To avoid damage to your hearing, make sure to turn the dial fully coun-
ter-clockwise before using headphones. Slowly turn the knob clockwise until a comfortable listening level is set. Normally, the signal in
the headphones is the Left/Right signal. If the Tape/CD to Control Room (10) switch is engaged, the tape/CD signal is also included.
(12) +48V Phantom Power Switch/LED
This switch a48 VDC to the XLR input connectors to power microphones that require phantom power. If phantom power is
used, do not connect unbalanced dynamic microphones or other device to the XLR inputs that cannot handle this voltage.
The yellow LED l48V will light when the switch is engaged.
(13) Power LED
This LED indicates AC power is being supplied to the unit, the power switch is on and the unit is functioning properly.
(14) LED Meters
Two 4-segment LED arrays are provided to monitor the levels of the Left/Right outputs. These meters range from -20 dB to +19dB. 0
dB on the meter corresponds to +4 dBu at the outputs.
(15) Tape/CD to Master
Pressing this switch routes the signal from the Tape/CD inputs (24) to the Main Outputs (26).
(16) Master Mix Level
The Master Mix Level controls the signal level being sent to the main Left/Right outputs. Best results are obtained when this control is
set near 12 o'clock.
19
27
18
17
